Centrifuges Greatly Enhance Fluid Recycling

June 2014, Vol. 69, No. 6

Drilling fluid additives and the water that contains them are an essential part and expense of successfully completing a horizontal directional drilling (HDD) installation, and the longer the bore and larger the product being installed, the more drilling fluids cost.

Therefore, it makes economic sense to recycle drilling fluids by removing cuttings and recirculating the cleaned fluids.

HDD fluid recycling technology has been adapted from the oil and gas drilling industry where it has been used for several decades. Today, projects employing midsize and even small drill rigs use separate fluid mixing and recycling systems. Most big projects use recycling packages that mix, pump, clean and recycle drilling fluids with equipment using a combination of screens, centrifugal pumps and hydrocyclones to remove the cuttings from the fluid.

Many drillers now are adding a new component to drilling fluid cleaning and recycling systems – a centrifuge.

“Integrating a high-speed decanter centrifuge with a conventional drilling fluid cleaning system removes ultra-fine solids that traditional shakers and hydrocyclones can’t remove,” said Michael Rai Anderson, P.E., president and chief executive officer of Kemtron Technologies. “This allows the driller to better manage drilling fluid weight. In theory, properly integrated centrifuge technology allows for the indefinite recirculation of drilling fluids.”

Kemtron is a leading manufacturer of drilling fluid cleaning and circulation systems, including centrifuges.

Anderson said with conventional mud cleaning systems, drilling fluid initially passes through the linear motion shale shaker capable of handling 100 percent of the mud pump, typically removing coarse-sized solid particles greater than 100 microns. The drilling fluid then passes through desander and/or desilter hydrocyclones for further removal of fine and silt-sized solid particles, ranging in size between 250 to 100 microns.

Centrifuge boost

Adding a high-speed, solids control decanter centrifuge removes ultra-fine drill solids of greater than 2 to 5 microns at an average process rate of approximately 20 percent of the mud pump flow rate, Anderson continued.

“Centrifuges can improve the cut point by a factor of six times when compared to a prototypical shaker/hydrocyclone system and can dramatically increase drilling fluid life,” he said. “Kemtron has experienced applications utilizing centrifuges in cooperation with the standard solids control equipment in which drilling fluid life was increased by a factor of 10.”

BJM pump

BJM pump
BJM Pump

The J-Series electric submersible pumps offer top performance and high quality for a very modest investment. The pumps are designed for long life and trouble free performance. The J-Series electric submersible pumps offer top performance and high quality for a very modest investment.